HP XP Racks - Manual (Page 679)

BCM Monitor stops after it finishes all the processes up to the ACTION=STOPPOINT label name,
which is specified in the YKMONCG file.
If the specified label name does not exist in the YKMONCG file, the request to stop BCM Monitor is
canceled.
Example
To stop a BCM Monitor instance whose identification name is YK, enter the following command.
STOP YK
To stop the BCM Monitor instance whose identification name is YK at the specified label
STOPPOINT(LABEL1)
, enter the following command.
MODIFY YK,STOP LABEL1
Remarks
•
If you use the STOP command in the operating system, it assumes that you specified the
following:
MODIFY
Δ
1
cataloged-procedure-for-startup-name[.identification-name]
,STOP
•
Even when you enter the MODIFY STOP command that contains IMMEDIATE, if BCM is
processing the CLI command, it will not stop until the command finishes.
•
If you enter a MODIFY STOP command after a MODIFY STOP command that contains
IMMEDIATE
, the latter command is not executed.
•
If you enter multiple MODIFY STOP or STOP commands, only the last command you entered
will be executed. However, if you enter a MODIFY STOP or STOP command after BCM
Monitor has already begun the stop process, that command is not executed.
Forcibly stopping BCM Monitor
To forcibly stop BCM Monitor, use the CANCEL command. When you use this command, all requests
are canceled and BCM Monitor is instantly stopped.
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command.
CANCEL
Δ
1
[cataloged-procedure-for-startup-name.]identification-name
If only the name of the cataloged procedure for startup was specified in the START command:
CANCEL
Δ
1
cataloged-procedure-for-startup-name
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when BCM Monitor was started.
identification-name
Starting and stopping the BCM Monitor 679