Press the f6=scan key. the scan result appears – HP XP Racks User Manual
Page 590
8.
Press the F6=Scan key.
The scan result appears.
Scan Device Address Extent
Command ===>
2008/03/19 14:56:47
Select one field from among Device Num, Volser, and Non Gen'ed by entering
"/". Next, specify any contiguous range of device address, and then press the
F6=Scan key to discover HP storage systems and devices.
Device Num ( / ) | Start: 7310 End: 731F
Volser ( ) | Start:
End:
Found 16 devices on 1 storage systems.
------------------------------------------------------------------------------
Non Gen'ed ( )
Supported action: s(Select)
AC
Non Gen'ed Device Address Domain . .
Storage System S/N . . . . . . . . .
Device Address | Start CU:
CCA:
| End CU:
CCA:
F1=Help F3=Exit F6=Scan F7=Backward F8=Forward F12=Cancel F17=DispConf
9.
Repeat steps 7 and 8 if you want to perform a local scan with another scope.
10.
Specify / for Non Gen'ed (NG scan execution specification), and specify DADP.NG for Non
Gen'ed Device Address Domain, 12345 for Storage System S/N, and a device address (CU,
CCA) in the scan range for Device Address.
Scan Device Address Extent
Command ===>
2008/03/19 15:04:11
Select one field from among Device Num, Volser, and Non Gen'ed by entering
"/". Next, specify any contiguous range of device address, and then press the
F6=Scan key to discover HP storage systems and devices.
Device Num ( ) | Start: 7310 End: 731F
Volser ( ) | Start:
End:
------------------------------------------------------------------------------
Non Gen'ed ( / )
Supported action: s(Select)
AC
Non Gen'ed Device Address Domain . . DADP.NG
Storage System S/N . . . . . . . . . 12345
Device Address | Start CU: 00 CCA: 00
| End CU: 00 CCA: FF
F1=Help F3=Exit F6=Scan F7=Backward F8=Forward F12=Cancel
11.
Press the F6=Scan key.
NOTE:
When using a command device during an NG scan, in the Set Defaults panel, specify
Y
for Remote DKC Function, and the route list of the first entry for the storage system subject
to the NG scan for Preset RouteListID.
An NG scan is performed and the CU Selection List for Edit devn panel is displayed.
CU Selection List for Edit devn Row 1 to 1 of 1
Command ===>
Scroll ===> PAGE
590 Using the ISPF panels