Operands, Example, Displaying or changing the log output level – HP XP Racks User Manual
Page 706: Displaying the log output level, Format, Operands example, Format operands example
CANCEL
∆
1
cataloged-procedure-for-startup-name
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when a Business Continuity Manager agent was started.
identification-name
Used to specify the identification name that was specified in the START command when a Business
Continuity Manager agent was started.
Example
To forcibly stop a Business Continuity Manager agent that was started and whose identification
name is YK, enter the following command:
CANCEL YK
Displaying or changing the log output level
This section describes the commands you can use to display or change the log level of a Business
Continuity Manager agent.
For the symbols used in the explanation on the format of commands, see
Displaying the log output level
To display the current Business Continuity Manager agent log output level, use the MODIFY
command with the DISPLAY LOGLEVEL parameter specified.
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
MODIFY
∆
1
[cataloged-procedure-for-startup-name.]identification-name
,DISPLAY LOGLEVEL
If only the name of the cataloged procedure for startup was specified in the START command:
MODIFY
∆
1
cataloged-procedure-for-startup-name
,DISPLAY LOGLEVEL
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when a Business Continuity Manager agent was started.
identification-name
Used to specify the identification name that was specified in the START command when a Business
Continuity Manager agent was started.
DISPLAY LOGLEVEL
Displays the current log output level.
Example
To display the current log output level of a Business Continuity Manager agent that was started
and whose identification name is YK, enter the following command:
706 Linkage with Replication Manager