Allocating physical paths to logical paths – HP XP Racks User Manual
Page 596
Allocating physical paths to logical paths
This section explains how to allocate physical paths to logical paths.
You do not need to perform this procedure if you are going to obtain the port number information
from a storage system and apply the port number that comprises the current logical path to the
path set definition file.
To obtain port number information from a storage system, see
“Acquiring path information from
, and make sure that the conditions are met.
For information about the data displayed in each ISPF panel, see the definition example in
logical path definition example” (page 592)
.
To allocate physical paths to logical paths:
1.
In the Edit Logical Path Definition panel, specify e in the AC column on the Forward line, and
then press the Enter key (to define a path from the primary site to the secondary site).
The screen display changes to the Edit Port Definition panel.
Edit Port Definition
Command ===>
Scroll ===> PAGE
2008/02/28 16:06:29
Supported action: d(Delete)
Path Set ID . . . : TESTPATH
Description . . . : TEST
S/N Model IFType PathID CU SSID
Primary . : 14002 USP 1515 00
Secondary : 14001 USP 1515 00
-------- Port ---------
AC Primary Dir Secondary
******************************* Bottom of data ********************************
F1=Help F3=Exit F5=Add F7=Backward F8=Forward F12=Cancel
2.
Press the F5=Add key.
The Assign Port panel is displayed.
3.
Specify 06 for Primary Port Number and 07 for Secondary Port Number.
Edit Port Definition
Command ===> ADD Scroll ===> PAGE
.----------------------------------------------. 8/02/28 16:06:29
Supported a | Assign Port |
Path Set ID | Command ===>
|
Description | |
| Enter the Port to assign: |
| |
Primary . : | Primary Port Number . . 06 |
Secondary : | Secondary Port Number . . 07 |
| |
------- | F1=Help F12=Cancel |
AC Primary '----------------------------------------------'
******************************* Bottom of data ********************************
F1=Help F3=Exit F5=Add F7=Backward F8=Forward F12=Cancel
NOTE:
The port number values used are the SAID values. The SAID values are documented
in the HP XP7 Continuous Access Synchronous for Mainframe Systems User Guide and the
HP XP7 Continuous Access Journal for Mainframe Systems User Guide.
596 Using the ISPF panels