HP XP Racks - Manual (Page 606)

CAA6060 NOT LOADED
b TESTPATH LOADED
******************************* Bottom of data ********************************
F1=Help F3=Exit F7=Backward F8=Forward F10=PrevInfo F11=NextInfo
F12=Cancel
The result is displayed under Status.
5. To obtain the status of the path, specify q in the AC column.
Manage Path Set Row 1 to 2 of 2
Command ===>
Scroll ===> PAGE
2008/02/28 16:53:07
Supported actions: l(Load), b(Build), d(Delete), q(Query), c(Correct mismatch)
AC Path Set ID ------------------------ Status ------------------------------
CAA6060 NOT LOADED
q TESTPATH BUILD SUCCESSFULLY
******************************* Bottom of data ********************************
F1=Help F3=Exit F7=Backward F8=Forward F10=PrevInfo F11=NextInfo
F12=Cancel
The screen display changes to the Path Set Status panel on which the status of the defined
path is displayed.
Path Set Status Row 1 to 4 of 4
Command ===>
Scroll ===> PAGE
2008/02/28 16:55:33
Supported actions: s(Show detail), b(Build), d(Delete), q(Query)
Path Set ID . . . : TESTPATH
Description . . . : TEST
--- Primary ---- -- Secondary ---
AC Type SN ID CU SSID Dir SN ID CU SSID Status
CU 14002 00 2340 -> 14001 00 2350 ESTABLISHED 1/1 PORT(S)
CU 14002 00 2340 <- 14001 00 2350 ESTABLISHED 1/1 PORT(S)
DKC 14002 00 -> 14001 00 ESTABLISHED 1/1 PORT(S)
DKC 14002 00 <- 14001 00 ESTABLISHED 1/1 PORT(S)
******************************* Bottom of data ********************************
F1=Help F3=Exit F4=Refresh F6=Sort F7=Backward F8=Forward
F12=Cancel
Defining a route list
This section explains how to define a route list for a 2DC configuration and a 3DC Multi-Target
(Cnt Ac-S Z x Cnt Ac-J Z) configuration and for multiple command device lines.
Defining a route list for a 2DC configuration
This section explains how to define a route list for a 2DC configuration by using the example shown
in the following figure.
In this example, assume that neither a Local Scan nor a Remote Scan has been performed for the
secondary site storage system.
606 Using the ISPF panels