Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 11)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 11
Chapter
1
Getting Started
The adapter is intended for installation in a PowerFlex 7-Class drive or Bulletin
150 SMC soft starter and is used for network communication.
Components
Topic Page
Components 11
Features 12
Compatible Products 13
Required Equipment 13
Safety Precautions 15
Quick Start 16
Item Part Description
➊ Status Indicators Four status indicators that indicate the status of the DPI, the
adapter, and network connection. See Chapter 7 , Troubleshooting .
➋ DPI Connector A 20-pin, single-row shrouded male header. An Internal Interface
cable is connected to this connector and a connector on the drive.
➌ Ethernet Connector RJ-45 connector for the Ethernet network cable. The connector is
CAT-5 compliant to ensure reliable data transfer on 100Base-TX
Ethernet connections.
➍ Web Pages Switch
(SW4)
Enables or disables the adapter web pages. See Setting the Web
Pages Switch on page 19 .
➎ Address/mode
switches
Set IP address or DHCP/BootP mode.
➊
➋
➌
➍
➎