Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 171)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 171
Appendix
B
Adapter Parameters
This appendix provides information about the adapter parameters.
About Parameter Numbers The parameters in the adapter are numbered consecutively. However, depending
on which configuration tool you use, they may have different numbers.
Parameter List
Topic Page
About Parameter Numbers 171
Parameter List 171
Configuration Tool Numbering Scheme
• HIM
• Connected Components Workbench software
• DriveExplorer
• DriveExecutive
The adapter parameters begin with parameter
01. For example, Parameter 01 - [DPI Port] is
parameter 01 as indicated by this manual.
• Explicit Messaging See Chapter 6 , Using Explicit Messaging and
Appendix C , EtherNet/IP Objects for details.
Parameter
No. Name and Description
Details
01 [DPI Port]
Displays the port to which the adapter is
connected. This will usually be port 5.
Default: 5
Minimum: 0
Maximum: 7
Type: Read Only
02 [DPI Data Rate]
Displays the data rate used by the drive. This data
rate is set in the drive and the adapter detects it.
Default: 0 = 125 kbps
Values: 0 = 125 kbps
1 = 500 kbps
Type: Read Only
03 [BOOTP/DHCP]
Configures the adapter to use BOOTP so that you
can set its IP address, subnet mask, and gateway
address with a BOOTP server.
Default: 1 = Enabled
Values: 0 = Disabled
1 = Enabled
Type: Read/Write
Reset Required: Yes