Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual - Manual (Page 13)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 13
Getting Started Chapter 1
Compatible Products
At the time of publication, the adapter is compatible with the following products:
Note: The adapter is not compatible with PowerFlex 750 series drives.
Required Equipment
Some of the equipment that is required for use with the adapter is shipped with
the adapter, but some you must supply yourself.
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes the following:
User-Supplied Equipment
To install and configure the adapter, you must supply the following:
• PowerFlex 70/70EC drives • PowerFlex 700L drives
• PowerFlex 700/700VC drives • PowerFlex Digital DC drives
• PowerFlex 700H drives • DPI External Comms Kit
• PowerFlex 700S drives • SMC™-50
• PowerFlex 7000/7000-2 drives • SMC™ Flex
❑ One 20-COMM-ER EtherNet/IP adapter
❑ One 2.54 cm (1 in.) long and one 15.24 cm (6 in.) long Internal Interface
cable (only one cable is needed to connect the adapter to the drive; for which
cable to use, see
Figure 3 - on page 2-21 )
❑ One PowerFlex 7-Class DPI (Drive Peripheral Interface) Network
Communication Adapter Installation Instructions, publication 20COMM-
IN004
❑ One LED Identification Label for use with Bulletin 150 SMC Flex and
Bulletin 700 PowerFlex drives
❑ A small flathead screwdriver
❑ Ethernet cable (for details, see the EtherNet/IP Media Planning and
Installation Manual, ODVA publication 148 available on the ODVA
website at
http://odva.org/Home/ODVATECHNOLOGIES/
EtherNetIP/EtherNetIPLibrary/tabid/76/Default.aspx )
❑ Ethernet switch (for details, see the Ethernet Design Considerations
Reference Manual, publication ENET-RM002)
❑ Configuration tool, such as the following:
– PowerFlex 20-HIM-xx HIM