Chapter 8, Viewing the adapter web pages, Chapter – Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual User Manual
Page 153: Accessing the adapter web home page, Viewing the web pages
Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013
153
Chapter
8
Viewing the Adapter Web Pages
This chapter provides instructions on how to monitor the adapter and connected
PowerFlex drive by using the adapter’s web interface.
Future enhancements may result in adapter web pages that look different than the
examples shown in this chapter.
Accessing the Adapter Web
Home Page
After configuring the adapter, you can view its web pages. These pages present
information about the adapter, the device to which it is connected, and other DPI
devices connected to or installed in the device such as a HIM or I/O card.
The adapter can be configured to automatically send email messages to desired
addresses when selected device faults occur and/or are cleared when the adapter
rakes a communication or idle fault action. Bit 0 of Parameter 57-[Web
Features]
can be used to protect the configured settings. For more details, see
.
Viewing the Web Pages
The adapter can be configured to automatically send e-mail messages to desired
addresses when selected drive faults occur and/or are cleared, and/or when the
adapter takes a communication or idle fault action.
Bit 0 of Parameter 57 - [Web Features] can be used to protect the configured
settings. For more details, see
1.
On a computer with access to the EtherNet/IP network on which the
adapter/device is installed, launch a web browser such as Microsoft
™
Internet Explorer, version 5.0 or later.
Topic
Page