Rockwell Automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Communication Adapter User Manual User Manual
Page 59
Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013
59
Configuring the I/O Chapter 4
2.
Click the Drive tab.
3.
Click Connect to Drive to begin the correlation process.
After the drive configuration data has been verified, a pop-up dialog box
appears, which synchronizes ports from the online drive to the project to
be sure that correct Datalinks are assigned.
4.
Click OK.
If the Differences Found screen appears—which is typical, click
Download. This will download the project settings from the controller
to the drive and its connected adapter. If Upload is clicked, the drive
and adapter settings are uploaded to the controller.
5.
When the Reset Comm Module screen appears, click Yes to reset the
communication adapter so that the new I/O settings take effect.
After resetting the communication module, which may take up to a minute
to complete, the I/O OK box in the upper-left of the RSLogix 5000
window should now be steady green and the yellow warning symbols
in
TIP
On subsequent connections to the drive (after initial download), click Upload.