Rockwell Automation MDF-SB1304F Kinetix 6000M Integrated Drive-Motor System - Manual (Page 126)

126 Rockwell Automation Publication 2094-UM003A-EN-P - May 2012
Appendix C Upgrading the Kinetix 6000M System Firmware
Verify the Firmware Upgrade Follow these steps to verify your firmware upgrade was successful. This procedure
uses an IDM unit as an example, but applies to IPIM modules too.
1. Open your RSLinx software.
2. From the Communications pull-down menu, choose RSWho.
3. Expand your Ethernet node, Logix backplane, and EtherNet/IP network
module.
4. Right-click the device (IPIM or IDM) and choose Device Properties.
The Device Properties dialog box opens.
5. Verify the new firmware revision level.
6. Click Close.
TIP Verifying the firmware upgrade is optional.