Rockwell Automation MDF-SB1304F Kinetix 6000M Integrated Drive-Motor System - Manual (Page 29)

Rockwell Automation Publication 2094-UM003A-EN-P - May 2012 29
Chapter
3
Mounting the Kinetix 6000M System
This chapter provides the system installation procedures for mounting your
Kinetix 6000M integrated drive-motor (IDM) unit and your power interface
module (IPIM).
This procedure assumes you have prepared your panel, mounted your Bulletin
2094 power rail, and understand how to bond your system. For installation
instructions regarding equipment and accessories not included here, refer to the
instructions that came with those products.
Topic Page
Mounting the IPIM Module 30
Installing the IDM Unit 33
SHOCK HAZARD: To avoid hazard of electrical shock, perform all mounting and
wiring of the Bulletin 2094 power rail and modules prior to applying power.
Once power is applied, connector terminals may have voltage present even
when not in use.
ATTENTION: Plan the installation of your system so that you can perform all
cutting, drilling, tapping, and welding with the system removed from the
enclosure. Because the system is of the open type construction, be careful to
keep any metal debris from falling into it. Metal debris or other foreign matter
can become lodged in the circuitry, which can result in damage to components.