Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 101)

Troubleshooting the Module and Network 9-13
46 EN Comm Flt The module has performed the “Comm Flt” action
specified by the user.
47 EN Idle Flt The module has performed the “Idle Flt” action
specified by the user.
48 PCCC IO Open The module has begun receiving PCCC Control
messages (the PCCC Control Timeout was
previously set to non-zero value).
49 PCCC IO Close The device sending PCCC Control messages to
the module has set the PCCC Control Timeout to
a value of 0.
50 PCCC IO Time Flt The module has not received a PCCC Control
message for longer than the PCCC Control
Timeout.
51 EN Sent Reset The module received a reset from the network.
52 Msg Ctrl Open The module has begun receiving Client-Server
Control messages (the Client-Server Control
Timeout was previously set to a non-zero value.)
53 Msg Ctrl Close The device sending Client-Server Control
messages to the module has set the Client-
Server Control Timeout to a value of zero.
54 Msg Ctrl Timeout The module has not received a Client-Server
Control message for longer than the established
timeout period.
55-59 Reserved
Module-Specific Events
60 BOOTP
Response The module received a response to its BOOTP
request.
61 E-mail Failed The module attempted to send an e-mail notice,
but could not deliver the message to the mail
server.
Table 9.7 – Event Codes and Descriptions
Code Event Description