Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 39)

Configuring the Scanner or Bridge 5-3
Step 3. In the list, select the EtherNet/IP scanner or bridge used
by your controller and then select the major revision of its
firmware in the Major Revision box. In this example (figure
5.3), we use a 1756-ENBT EtherNet/IP Bridge (Series A),
so the 1756-ENBT/A option is selected.
Step 4. Click OK. The Module Properties dialog box (figure 5.4)
appears.
Step 5. Edit the fields listed in table 5.1 in the Module Properties
Dialog Box.
Figure 5.3 – Select Module Type Dialog Box
Figure 5.4 – Module Properties Dialog Box - Page 1
Reliance Electric