Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 111)

Viewing the Module’s Web Pages 10-9
10.2.4 Configure E-mail Notification Web Page
The Configure E-mail Notification web page contains selections and
data fields for configuring the module to automatically send e-mail
messages to desired addresses when selected types of events
occur. By default, this configuration is not protected. After
configuration, the settings can be protected by setting Web
Features (parameter 30) E-mail Cfg Bit 0 value to “0” (Disabled). To
change a protected configuration, it must first be unprotected by
setting the E-mail Cfg Bit 0 value back to “1” (Enabled).
10.2.4.1To Configure E-mail Notification
Step 1. Click the desired Host Faults check boxes you want to
occur that will send e-mail notification.
• If you only want e-mail notification when specific faults
occur, click this radio button and type the fault numbers in
the box.
• If you only want e-mail notification when all faults except
specific faults occur, click this radio button and type the
fault numbers in the box.
Step 2. Click the desired Module Faults check boxes you want to
occur that will send e-mail notification.