Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 37)

Configuring the Scanner or Bridge 5-1
C
HAPTER
5
Configuring the
Scanner or Bridge
Chapter 5 provides instructions on how to configure a ControlLogix
bridge to communicate with the module and connected MD65 drive.
5.1 Configuring a Simple Network: An
Example
After the module is configured, the connected drive and module will
be a single node on the network. This chapter provides the steps
that are needed to configure a simple network like the network in
figure 5.1.
In our example, we will configure a 1756-ENBT (series A) bridge to
communicate with a drive using Logic Command/Status and
Reference/Feedback over the network.
Figure 5.1 – Sample EtherNet/IP Network
IP Address 131.200.130.176
ControlLogix Controller with
1756-ENBT Bridge
IP Address 131.200.130.178
MD65Drive with
EtherNet/IP Module
Computer with Ethernet Connection