Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 26)

4-4 EtherNet/IP Communications Module
Step 3. In the BOOTP Request History list, double-click the
hardware address (Ethernet MAC address) of the
module. The New Entry dialog box is displayed as shown
in figure 4.2.
Step 4. Edit the fields shown in table 4.3 in the New Entry Dialog
box:
Figure 4.1 – BOOTP Server Window
Figure 4.2 – New Entry Dialog Box
Table 4.3 – Editing the New Entry Dialog Box
In this field: Enter this information:
IP Address 1
1 For definitions, refer to the Glossary.
A unique IP address for the module.
Subnet Mask 1 A subnet mask for the module’s network.
Gateway 1 The IP address of the gateway device on the
module’s network.