Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 173)

Index Index - 1
I
NDEX
A
assembly object , C-4
assistance, technical , 1-2
B
BOOTP (2) , B-2
BOOTP (Bootstrap Protocol)
configuring the module using , 4-3
disabling , 4-6
bridge, configuring , 5-1 to 5-9
C
checklist, installation , 2-3
Comm Flt Action (18) , B-5
commissioning the module , 3-6
communications specifications , A-1
configuration tools , 4-1
configuring the module , 4-1 to 4-12
configuring the scanner or bridge , 5-1 to
5-9
connecting the module to the drive , 3-3
connecting the module to the
network , 3-5
connector
Ethernet , 2-1
MDI , 2-1
ControlLogix I/O image , 6-2
D
data rate, setting , 4-8
Datalinks, using , 6-3
dimensions, module , A-1
downloading the I/O configuration , 5-9
DPI ports , 3-4
DRIVE status indicator , 8-2
Drv 0 Addr (24) , B-8
Drv 1 Addr (25) , B-8
Drv 2 Addr (26) , B-8
Drv 3 Addr (27) , B-8
Drv 4 Addr (28) , B-8
E
EN Rate Act (16) , B-4
EN Rate Cfg (15) , B-4
equipment required for installation , 2-2
Ethernet connector , 2-1
Ethernet link object , C-33
events
codes and descriptions , 8-11
viewing and clearing , 8-11
example
Explicit Messages , 7-5
Get Attribute Single message , 7-6
ladder logic program , 6-3 to 6-7
network configuration , 5-1 to 5-9
Set Attribute Single message , 7-8
Explicit Message examples , 7-5
explicit messaging, using , 7-1
F
fault configuration parameters,
setting , 4-10
Flt Cfg Logic (20) , B-6
Flt Cfg Ref (21) , B-7
G
gateway address
setting using BOOTP , 4-3
setting using parameters , 4-7
Gateway Cfg 1 (11) , B-3
Gateway Cfg 2 (12) , B-3
Gateway Cfg 3 (13) , B-3
Gateway Cfg 4 (14) , B-3
Get Attribute Single message
example , 7-6
I
I/O configuration
adding a bridge or scanner , 5-2
adding the module and drive , 5-4
saving , 5-4 , 5-9
I/O configuration, setting , 4-8