Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 3)

Contents I
C
ONTENTS
Chapter 1 Introduction
1.1 Module Features............................................................ 1-1
1.2 Related Documentation ................................................. 1-2
1.3 Getting Assistance from Reliance Electric..................... 1-2
Chapter 2 Getting Started
2.1 Required Equipment ...................................................... 2-2
2.2 Installation Checklist ...................................................... 2-3
Chapter 3 Installing the EtherNet/IP Module
3.1 Preparing for an Installation........................................... 3-1
3.2 Setting Operating Mode and Web Pages Switches....... 3-1
3.3 Connecting the Module to the Drive .............................. 3-3
3.4 Connecting the Module to the Network.......................... 3-5
3.5 Applying Power.............................................................. 3-6
3.6 Commissioning the Module ........................................... 3-6
Chapter 4 Configuring the EtherNet/IP Module
4.1 Configuration Tools........................................................ 4-1
4.2 Using the LCD OIM or CopyCat Keypad to Configure
the Module ................................................................... 4-2
4.3 Using BOOTP to Set the IP Address, Subnet Mask, and
Gateway Address .......................................................... 4-3
4.4 Using Parameters to Set the IP Address, Subnet Mask, and
Gateway Address .......................................................... 4-6
4.5 Setting the Data Rate .................................................... 4-8
4.6 Setting the I/O Configuration ......................................... 4-8
4.7 Setting a Fault Action..................................................... 4-9
4.7.1 Setting the Fault Configuration Parameters ...... 4-10
4.7.2 Resetting the Module......................................... 4-11
4.8 Viewing the Module Configuration ............................... 4-12
4.9 Setting Web Features Access ..................................... 4-12
4.9.1 To Enable the Module Web Pages.................... 4-13
Chapter 5 Configuring the Scanner or Bridge
5.1 Configuring a Simple Network: An Example.................. 5-1
5.2 Adding a Bridge or Scanner to the I/O Configuration .... 5-2
5.3 Adding the Module and Drive to the
I/O Configuration ........................................................... 5-4
5.4 Saving the Configuration ............................................... 5-9
Chapter 6 Using I/O Messaging
6.1 About I/O Messaging ................................................. ..6-1
6.2 Understanding the I/O Image......................................... 6-2