Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 27)

Configuring the EtherNet/IP Module 4-5
Step 5. Click OK to apply the settings. The module appears in the
Relation List with the new settings as shown in figure 4.3.
Step 6. To assign this configuration to the module permanently,
click Disable BOOTP. When power is cycled on the
module, it will use the configuration you assigned it and
will not issue new BOOTP requests.
Note: To enable BOOTP for a module that has had
BOOTP disabled:
a. Select the module in the Relation List
b. Click Enable BOOTP.
c. Reset the module.
Step 7. To save the Relation List, select File > Save.
Figure 4.3 – BOOTP Server Window with a Module in the Relation List