Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 112)

10-10 EtherNet/IP Communications Module
Step 3. Type the following information in the respective box:
Step 4. Click Save Changes.
Important:It is recommended that Web Features (parameter 30) E-
mail Cfg Bit 0 value to be set to “0” (Disabled) after E-
mail Notification has been configured. Otherwise the
configuration can be changed anytime the web page is
accessed with a browser.
An example of an e-mail message automatically sent by the module
in response to selected events is shown below.
10.2.4.2Stopping E-mail messages
To stop e-mail messages, do one of the following:
• Delete all e-mail addresses from the Configure E-mail Notification
web page.
• Uncheck all of the “Send an e-mail message when...” boxes.
Disabling the module web pages by setting the Web Pages Switch
(SW2 in figure 3.1) to the “Disable Web” position will NOT stop the
module from sending e-mail messages.
Information Description
“IP address of...” Type in the address of the mail server that
will be used to deliver the e-mail messages.
“E-mail addresses
to notify...” Type in addresses to where you want e-mail
messages to be sent. Multiple addresses
can be used, but they must be separated by
commas (comma delimited).
“Subject of e-mail
message...” Type in the desired subject text for the e-
mail message.
To: [email protected]
cc:
Subject: Notice from example drive
Seq C - The MDI host "MD65 4C 1P 1:0V .50HP" at 10.91.97.59. Please do not reply to this message,
as the module cannot process replies.
The MDI host has logged the following fault (trip):
Fault code: 4
Fault text: UnderVoltage
See the device's Web page at httop://10.91.97.59.
MDCOMM-ENET @10.91.97.59 on 12/05/2003 09:25:10 AM