Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 17)

Installing the EtherNet/IP Module 3-1
C
HAPTER
3
Installing the
EtherNet/IP Module
Chapter 3 provides instructions for installing the module on an
MD65 drive.
3.1 Preparing for an Installation
Before installing the module:
• Read the EtherNet/IP Performance and Application Guide,
publication ENET-AP001..., and EtherNet/IP Media Planning and
Installation Manual, publication ENET-IN001...
• Verify that you have all required equipment. Refer to chapter 2,
Getting Started, for a list of equipment.
Important: To guard against device malfunction, you must wear a
grounding wrist strap when installing the EtherNet/IP
module.
3.2 Setting Operating Mode and Web
Pages Switches
Before installing your module, you must set its Operating Mode
Switch for Single or Multi-Drive operation. To use the adapter web
pages, the Web Pages Switch must be set to its “Enable Web”
position.
Important: New settings are recognized only when power is
applied to the module, or the module is reset. If you
change a setting, cycle power or reset the module.
!
ATTENTION: The EtherNet/IP module contains
ESD- (Electrostatic Discharge) sensitive parts that
can be damaged if you do not follow ESD control
procedures. Static control precautions are required
when handling the module. Failure to observe these
precautions could result in damage to equipment.