Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 17)

Getting Started 2-1
C
HAPTER
2
Getting Started
This chapter provides:
• A description of the EtherNet/IP module’s components
• A list of parts shipped with the module
• A list of user-supplied parts required for installing the module
• An installation checklist
➀ Status Indicators Four LEDs to indicate the status of the connected
drive, module, and network. Refer to chapter 6 for
more information about the LEDs.
➁
DPI Connector A 20-pin, single-row shrouded male header. An
Internal Interface cable connects to this connector
and one on the drive.
➂ Ethernet
Connector An RJ-45 connector the Ethernet cable. The
connector is CAT-5 compliant to ensure reliable
data transfer on 100Base-TX Ethernet
connections.
④ Web Page
Switch (SW2) Enables or disables the module web pages. Refer
to Chapter 3, Setting the Web Pages Switch
(Firmware 3.xxx only). SW1 is unused.
Figure 2.1 – Components of the EtherNet/IP Module
–
—
˜ ™ Not provided on
firmware version 2.xxx
or earlier