Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 48)

Configuring the EtherNet/IP Module 4-22
4.12 Viewing the Module Configuration
The parameters in table 4.5 provide information about how the
module is configured. You can view these parameters at any time.
Table 4.5 – Module Configuration Parameters
No Name and Description Details
17 EN Rate Act
The actual network data rate.
Values 0 = No Link
1 = 10 Mbps Full
2 = 10 Mbps Half
3 = 100 Mbps Full
4 = 100 Mbps Half
Type: Read Only
18 Ref / Fdbk Size
Size of the Reference/Feedback. The drive
determines the size of the Reference/Feedback.
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
19 Datalink Size
Size of each Datalink word. The drive determines
the size of Datalinks.
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
24 DPI I/O Act
I/O that the module is actively transmitting. The
value of this parameter will usually be equal to the
value of parameter 23 (DPI I/O Config).
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read Only
Bit Definitions
0 = Cmd/Ref
1 = Datalink A
2 = Datalink B
3 = Datalink C
4 = Datalink D
5 = Not Used
6 = Not Used
7 = Not Used
48 Peer Inp Status
Status of the consumed peer input connection.
Values: 0 = Off
1 = Waiting
2 = Running
3 = Faulted
Type: Read Only
Bit
Default 1 0 0 0 0 x x x
0 1 2 3 4 5 7 6