Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 21)

Installing the EtherNet/IP Module 3-1
C
HAPTER
3
Installing the
EtherNet/IP Module
Chapter 3 provides instructions for installing the module on
Reliance Electric drives.
3.1 Preparing for an Installation
Before installing the module:
• Read the EtherNet/IP Performance and Application Guide,
publication ENET-AP001..., and EtherNet/IP Media Planning and
Installation Manual, publication ENET-IN001...
• Verify that you have all required equipment. Refer to chapter 2,
Getting Started, for a list of equipment.
Important: To guard against device malfunction, you must wear a
grounding wrist strap when installing the EtherNet/IP
module.
3.2 Setting the Web Pages Switch
(Version 3.xxx)
To use the module web pages, the Web Pages Switch (not provided
on version 2.xxx and earlier modules) must be set to its “Enable
Web” position.
Important: A new setting is recognized only when power is
applied to the module, or the module is reset. If you
change a setting, cycle power or reset the module.
!
ATTENTION: The EtherNet/IP module contains
ESD- (Electrostatic Discharge) sensitive parts that
can be damaged if you do not follow ESD control
procedures. Static control precautions are required
when handling the module. Failure to observe these
precautions could result in damage to equipment.