Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 187)

Index Index - 1
I
NDEX
A
Access Control (54) , B-16
assembly object , C-4
assistance, technical , 1-3
B
BOOTP (3) , B-2
BOOTP (Bootstrap Protocol)
configuring the module using , 4-3
disabling , 4-6
bridge, configuring , 5-1 to 5-9
C
checklist, installation , 2-3
Comm Flt Action (21) , 4-17 , B-6
commissioning the module , 3-6
communications specifications , A-1
configuration tools , 4-1
configuring the module , 4-1 to 4-22
configuring the scanner or bridge , 5-1 to
5-9
connecting the module to the drive , 3-2
connecting the module to the
network , 3-5
connector
DPI , 2-1
Ethernet , 2-1
ControlLogix I/O image , 6-3
D
data rate, setting , 4-8
Datalink Size (19) , B-5
Datalinks, using , 6-7
dimensions, module , A-1
downloading the I/O configuration , 5-9
DPI alarm object , C-27
DPI connector , 2-1
DPI Data Rate (2) , B-2
DPI device object , C-17
DPI diagnostic object , C-29
DPI fault object , C-25
DPI I/O Active (24) , B-8
DPI I/O Config (23) , B-7
DPI parameter object , C-20
DPI Port (1) , B-2
DPI ports , 3-3
DPI time object , C-31
DRIVE status indicator , 8-2
E
EN Rate Act (17) , B-5
EN Rate Cfg (16) , B-4
equipment required for installation , 2-2
Ethernet connector , 2-1
Ethernet link object , C-35
events
codes and descriptions , 8-10
viewing and clearing , 8-9
example
Explicit Messages , 7-5
Get Attribute Single message , 7-6
Get Attributes Scattered
message , 7-10
ladder logic program , 6-9 to 6-13
network configuration , 5-1 to 5-9
Set Attribute Single message , 7-8
Set Attributes Scattered message
example , 7-14
Explicit Message examples , 7-5
explicit messaging, using , 7-1 to 7-17
F
fault action, setting , 4-17
fault configuration parameters,
setting , 4-19
Flt Cfg A1 (27) , B-9
Flt Cfg A2 (28) , B-9
Flt Cfg B1 (29) , B-9
Flt Cfg B2 (30) , B-9
Flt Cfg C1 (31) , B-9
Flt Cfg C2 (32) , B-9
Flt Cfg D1 (33) , B-9
Flt Cfg D2 (34) , B-9
Flt Cfg Logic (25) , B-8