Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 18)

2-2 EtherNet/IP Communcations Module
2.1 Required Equipment
Table 2.1 lists the equipment shipped with the EtherNet/IP module.
When you unpack the module, verify that the package includes all of
these items.
To install and configure the EtherNet/IP module, you must supply
the items listed in table 2.2.
Table 2.1 – Equipment Shipped with the EtherNet/IP Module
Item Description
One EtherNet/IP Communications module
One 2.54 cm (1 in) and one 15.24 cm (6 in) Internal Interface cable
(only one of these cables is needed to connect the module to the
drive)
One EtherNet/IP Communications module User Manual (D2-3510)
Table 2.2 – User-Supplied Items Required for Installation
Item Description
Small flathead or Phillips screwdriver
Ethernet cable (Refer to the EtherNet/IP Media Planning and
Installation Manual, publication ENET-IN001..., for details.)
Configuration tool, such as
• SP600 LCD OIM, GV6000 LCD OIM, or LiquiFlo 2.0 LCD OIM
• VS Utilities
• BOOTP Server (version 2.1 or higher) for network setup only
Controller configuration software (for example: RSLogix 5,
RSLogix 500, RSLogix 5000 software)
PC connection to the EtherNet/IP network.