Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 3)

Contents I
C
ONTENTS
Chapter 1 Introduction
1.1 Module Features............................................................ 1-1
1.2 Compatible Products ..................................................... 1-2
1.3 Related Documentation ................................................. 1-2
1.4 Getting Assistance from Reliance Electric..................... 1-3
Chapter 2 Getting Started
2.1 Required Equipment ...................................................... 2-2
2.2 Installation Checklist ...................................................... 2-3
Chapter 3 Installing the EtherNet/IP Module
3.1 Preparing for an Installation........................................... 3-1
3.2 Setting the Web Pages Switch (Version 3.xxx) ............. 3-1
3.3 Connecting the Module to the Drive .............................. 3-2
3.4 Connecting the Module to the Network.......................... 3-5
3.5 Applying Power.............................................................. 3-6
3.6 Commissioning the Module ........................................... 3-6
Chapter 4 Configuring the EtherNet/IP Module
4.1 Configuration Tools........................................................ 4-1
4.2 Using the LCD OIM to Configure the Module ................ 4-2
4.2.1 SP600 and LiquiFlo 2.0 ....................................... 4-2
4.2.2 GV6000 ............................................................... 4-3
4.3 Using BOOTP to Set the IP Address, Subnet Mask,
and Gateway Address .................................................. 4-3
4.4 Using Parameters to Set the IP Address, Subnet Mask,
and Gateway Address .................................................. 4-6
4.5 Setting the Data Rate .................................................... 4-8
4.6 Setting the I/O Configuration ......................................... 4-8
4.7 Setting the Reference Adjustment ............................... 4-10
4.8 Selecting a Master-Slave or Peer-to-Peer Hierarchy... 4-10
4.8.1 Configuring the Module for a Master-Slave
Hierarchy.......................................................... 4-11
4.8.2 Configuring the Module to Transmit Peer-to-Peer
Data................................................................... 4-12
4.8.3 Configuring the Module to Receive Peer-to-Peer
Data................................................................... 4-13
4.9 Setting a Fault Action................................................... 4-17
4.9.1 Setting the Fault Configuration Parameters ...... 4-19