ADLINK AMP-208C - Manual (Page 138)

Motion Control Theory 124
AMP-204C / AMP-208C
Motion status is described below in sequence of bit:
Bit0~ bit4:
CSTP (Command stop):
When this signal is ON, the controller
is not sending movement command.
VM:
when this signal is ON, the movement reached its
maximum velocity settings.
ACC:
when this signal is ON, the movement is accelerating.
DEC:
when this signal is ON, the movement is decelerating.
DIR:
when this signal is ON, the movement is moving at
positive direction. When movement stops, the DIR saves
status right before movement stopped.
15 JOG Jog movement in progress
16 ASTP
Abnormal stop. Clear this signal after next
movement is executed
17 BLD The axis is running blending movement
18 PRED
Pre-offset event, clear this signal after next
movement is executed
19 POSTD
Post-offset event, clear this signal after next
movement is executed
20~27 -- (Reserved)
28 GER In geared, the axis is a slave one
29~31 -- (Reserved)
Bit No. Define Description