Figure 1-1, Amp-204c/208csystem block diagram – ADLINK AMP-208C User Manual
Page 16
Advertising
2
Introduction
Figure 1-1: AMP-204C/208Csystem block diagram
Graphical motion control interface
– MotionCreatorPro 2 is a
Windows-based motion control software development tool for
motion control and I/O status monitoring. It captures motion curves
and data at the same time for analysis. Its Setup Wizard guides
you through the hardware installation and wiring as well as
single-axis manipulation step-by-step. This saves your
development time and cost.
PCI Bus
PCI Bus
SCS
I 100
P
DIN-825-GP4
Is
olati
on
DSUB 37P
Advertising
This manual is related to the following products: