ADLINK AMP-208C - Manual (Page 37)

Getting Start with The Installation 23
AMP-204C / AMP-208C
2.6 DIP Switch
2.6.1 SW2: Card ID Switch
This switch is used for adjusting card ID for easy identification in
user application programs. Take example. If you set card ID to
“0-0-0-1” (OFF-OFF-OFF-ON) then
the card ID is “1” and the ID table
should be set up as described below:
Card ID Switch Setting (ON=1)
0 0000
1 0001
2 0010
3 0011
4 0100
5 0101
6 0110
7 0111
8 1000
9 1001
10 1010
11 1011
12 1100
13 1101
14 1110
15 1111 (default)