ADLINK AMP-208C - Manual (Page 66)

52 Signal Connection
3.9 Comapre & Trigger Output:
AMP-204C / AMP-208C provides 2/4 comparing trigger pulse
output channels. Each comparing trigger channel can output pulse
commands up to 1 MHZ. See Section 4.9.2 for its detail and how
to use it. See below for corresponding pins of pulse command
output against differential pulse signals to DIN-825-GP4:
• Signal connection diagram:
1. Line Driver interface:
Figure 3-10: Line Driver type compare trigger signal connection example
J3 Pin No Signal Name Description
2 TRG2-/TRG4- Trigger output (-), (2)/(4)
3 TRG2+ / TGR4+ Trigger output (+), (2)/(4)
4 TRG1-/TRG3- Trigger output (-), (1)/(3)
5 TRG1+/TRG3+ Trigger output (+), (1)/(3)
NOTE NOTE
The compare trigger pulse output channel of AMP-204C /
AMP-208C employs line driver output interface for better noise
signal resistance and wiring length where trigger output (3) &
(4) require #2 DIN-825-GP4 for wiring.