H3C Technologies H3C Intelligent Management Center - Manual (Page 224)

202
10 Managing Comware-based fat APs
WSM enables administrators to create and manage wireless networks through fat APs. IMC WSM
automatically manages all fat APs that are added to the IMC Platform. Figure 53 shows the fat AP
network.
Figure 53 Fat AP network
Before you create a new fat AP network in WSM, complete the following tasks:
• Configure the fat AP so that it can access the network.
• Configure an SNMP community on the fat AP, and add the fat AP to the IMC Platform.
To create a fat AP network in WSM:
1. Create WLAN BSS interfaces for fat APs in batches, and modify the port security mode and
VLANs for WLAN BSS interfaces in batches.
For more information, see "
Configuring WLAN BSS interfaces in batches ."
2. Create service policies for fat APs in batches. For more information, see " Configuring service
policies in batches ."
3. Optional: Configure the same parameters for radios of fat APs in batches.
For more information, see "
Configuring radios in batches ."
4. Modify radio parameters for a single fat AP, bind radios to service policies, and specify the
wireless logical interfaces to use.
For more information, see "
Configuring a radio policy ."
To manage an existing wireless network, you only need to manage the fat APs in WSM without
creating a fat AP network in WSM.