H3C Technologies H3C Intelligent Management Center - Manual (Page 537)

515
3. Click Synchronize.
4. Enter the Interferences page again after synchronization.
The Current Interference List displays all interferences.
Current Interference List
{
Interference Type—Type of the interference. Interference types follow:
− Microwave Oven
− Bluetooth
− Fixed-Frequency
− Fixed-Frequency (Video)
− Cordless Phone
− Microsoft Xbox
{
Sensitivity—Severity level of the interference, in the range of 0 to 100. A higher value
indicates a higher interference.
{
RSSI—Signal strength of the interference.
{
Duty Cycle (%)—Duty cycle of the interference. Duty cycle is the time when the interference
device was active. You can view the duty cycle on the device.
{
Affected Channel—Channel affected by the interference.
{
AP Label—Label of the AP to which the radio (that detected the interference) belongs. Click
the label of the AP to view details.
{
Location—Location view to which the interference belongs. WSM locates the interference to
the location view of the AP that detected the interference. Click the location view name to
view the location view topology.
{
Detected Time—Time when the AP detected the interference.
{
Operation—Click the Operation icon for the interference to display the operation menu.
From the Operation menu, you can select View Topology to locate the interference in
the topology.
If the Current Interference List contains enough entries, the following navigational aids are
displayed.
{
Click the Next Page icon to page forward in the Current Interference List.
{
Click the Last Page icon to page forward to the end of the Current Interference List.
{
Click the Previous Page icon to page backward in the Current Interference List.
{
Click the First Page icon to page backward to the front of the Current Interference List.
Click 8, 15, 50, 100, or 200 at the upper right of the Current Interference List to specify the
number of items you want to display on each page.
NOTE:
You can sort the Current Interference List by every field except the Operation field. Click the column
label to sort the list by the selected field. The column label allows you to toggle between the various sort
options specific to each field.