H3C Technologies H3C Intelligent Management Center - Manual (Page 444)

422
specified time, it removes the wireless device. The valid time range is 60 to 2592000
seconds, and the default is 86400 seconds.
{
Re-categorization period (s)—Specify the time interval at which WIPS re-categorizes detected
APs. The valid time range is 10 to 36000 seconds, and the default is 600 seconds.
{
Traffic statistics periods (s)—Specify the interval at which APs sends collected traffic data to
the AC. The valid time range is 60 to 86400 seconds, and the default is 900 seconds.
{
Dynamic Trust List Aging Time (s)—Specify the aging time for the wireless devices in the
dynamic trust list, in the range of 60 to 3600 seconds. The default is 60 seconds. When the
aging time of a device in the list expires, WIPS removes the device from the list if it cannot
detect the device any more. This parameter only takes effect on the dynamic trust list.
{
Device Status Update Interval (s)—Set the information update interval for wireless devices.
When this interval is set, a sensor notifies the AC of the current state of the wireless devices
at the specified interval when their information does not change so that the AC can get the
wireless device status in time.
4. Click OK.
Configuring the permitted channel list
You can configure a permitted channel list in a WLAN. WIPS generates alarms when detecting
packet transmission on any channel not in the permitted channel list.
To configure the permitted channel list:
1. Access the WIPS Management page.
2. Click the Permitted Channel List tab.
The permitted channel list displays all channels supported by 802.11. Some channels are
grayed out when you select different ACs because they support different country codes.
3. Select the channels to add to the permitted channel list. To add all supported channels to the
permitted channel list, select Select All.
4. Click OK.
Configuring the static trusted address list
The static trusted address list contains MAC addresses of all manually configured trusted devices.
Viewing the static trusted address list
1. Access the WIPS Management page.
2. Click the Static Trusted Address List tab.
The static trusted address list displays all manually configured trusted MAC addresses.
{
MAC Address—MAC address of the device.
{
Vendor—Vendor of the device or NIC. IMC uses the MAC address to identify the vendor of
the device or NIC. If the MAC address is not an OUI MAC address or a legal MAC address,
the field displays Unknown.
{
Delete—Allows you to delete the MAC address.
If the static trusted address list contains enough entries, the following navigational aids are
displayed: