Ap channel quality statistics report – H3C Technologies H3C Intelligent Management Center User Manual
Page 680
658
Figure 114 Site access points and neighbors
Site access points and neighbors report fields:
•
Location—Name of the location view for which the statistics are collected or All AP Devices.
•
Radio BSSID—Radio BSSID of the detected neighbor AP.
•
SSID—SSID of the detected neighbor AP.
•
Wireless Mode—Wireless mode of the detected neighbor AP.
•
Channel—Channel of the detected neighbor AP.
•
SNR (dB)—Signal-to-noise ratio of the detected neighbor AP.
•
Signal (dBm)—Signal strength of the detected neighbor AP.
•
Noise (dBm)—Noise level of the detected neighbor AP.
•
Detected By—Access point name by which the neighbor AP is detected.
AP channel quality statistics report
To view an AP channel quality statistics report, configure the following parameters:
•
Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or
select Custom Range, and then specify the start time and end time manually.
•
Location—Select a specific location view for statistics collection, or select All AP Devices.
•
Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
shows an example AP channel quality statistics report.