H3C Technologies H3C Intelligent Management Center - Manual (Page 80)

58
For HP MSM410/MSM430/MSM460/MSM466/MSM466-R APs, WSM enables you to
configure the Neighborhood scanning parameters.
{
Scan Ratio(%)—Enter the percentage of time spent on scanning channels other than the
operating channel. This parameter appears only when the Operating Mode of the radio is
Access point only.
{
Dwell Time(ms)—Enter the amount of time (in milliseconds) that a radio remains on a
channel while performing channel scanning.
{
Scan Mode—Select a scan mode for the radio. Options are Passive and Active.
− Passive—The AP listens to the channel to detect wireless traffic, but does not transmit any
probes.
− Active—The AP uses probe request frames to speed up neighbor detection.
{
Bands to Scan—Select the bands to scan. Options are Both Bands and Operating band only.
− Both Bands—The AP scans both the 2.4GHz and 5GHz bands.
− Operating band only—The AP scans the operating band only.
{
Channels to Scan—Select the channels to scan. Options are All channels, Regulatory
channels only, and Non-excluded channels only.
− All channels—The AP scans all the channels in the band where the radio is operating.
− Regulatory channels only—The AP scans only the channels supported by the country
code of the radio.
− Non-excluded channels only—The AP will not scan any channels in the automatic
channel exclusion list.
7. Click OK.
Configuring AP monitor status for a group
WSM enables you to configure AP monitor status for a group. The AP monitor status for a group can
be inherited by fit APs in the group.
1. Click the Service tab.
From the navigation tree, select WLAN Manager > Resource Management > ACs. The AC List
page displays all ACs.
2. Click the Operation icon for the target AC.
Select Group Configuration from the menu.
The Group List displays all fit AP groups on the AC.
3. Click the Configure AP Monitor Status icon .
The Configure AP Monitor Status page appears.
4. Modify the AP monitor parameters for the group:
{
Group Name—Group name, which cannot be modified.
{
Inherited—Click the box to enable the group to inherit the AP monitor status from the AC. Or
clear the box and then manually configure the AP Monitor Status for the group.
{
AP Monitor Status—Select an AP monitor status for the group. Options are Enable and
Disable. This parameter is valid only when the Inherited box is not selected.
5. Click OK.