Rogue client history report – H3C Technologies H3C Intelligent Management Center User Manual
Page 661
639
No specific parameters are required for viewing a rogue AP report.
shows an example rogue AP report.
Figure 99 Rogue AP report
Rogue AP report fields:
•
MAC Address—MAC address of the rogue AP.
•
Vendor—Vendor of the rogue AP.
•
SSID—SSID of the rogue AP.
•
Max Signal Strength—Maximum signal strength of the rogue AP.
•
Channel—Channel used by the rogue AP.
•
Detected by—AC that detected the rogue AP.
•
Last Discovered Time—Time when the rogue AP was last discovered.
•
Attacked Status—State of the rogue AP, Attacked or Not Attacked.
Rogue client history report
This report displays the history records of detected rogue clients by MAC address.
To view a rogue client history report, configure the following parameters:
•
Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or
select Custom Range, and then specify the start time and end time manually.