Grass Valley EDIUS Neo 3 User Manual
Page 249
EDIUS NEO — User Reference Guide
247
Clip Operations
3.
Set the desired video or audio Out point.
Note
The procedure is the same for marking an Out point for video or audio only
except the list button (
) on the Out button is clicked.
You may also set the
In
and
Out
buttons to one of three modes such that
clicking on the button sets the In or Out point according to the selected
mode:
•
Video Only
•
Audio Only
•
Video and Audio
To change the
In/Out
button mode, click the In/Out toggle button in the
bottom left corner of the Player window (see
).
Figure 250. In/Out Mark Toggle Button
The
In
and
Out
buttons in
mark the In and Out point for both
audio and video as there is no video or audio symbol on the buttons.
Each click of the toggle button selects a different mode and changes the
In
and
Out
button icon in the Player as follows:
Set Video In
Set Video Out
Set Audio In
Set Audio Out
With In and Out points set separately for video and audio the position bar
in the player is divided horizontally into two sections. The upper (yellow)
section represents the video and the lower (green) section the audio. See
for an example.
Note
If the position bar is not divided, place the mouse cursor at the far right or far
left edge of the position bar. Click the left mouse button while holding down
the [CTRL] key and the position bar is divided.
Figure 251. Split Position Bar for Video and Audio