Grass Valley EDIUS Neo 3 - Manual (Page 417)

EDIUS NEO — User Reference Guide 415
Trimming Clips
The trimming mode changes according to the selected In and Out points.
For more information on trimming modes, see the following references:
• Ripple Trim on page 420
• Split Trim on page 425
• Slide Trim on page 427
• Slip Trim on page 429
• Rolling Trim on page 430
4. Position the mouse cursor on the Preview window and drag to the right
or to the left when the mouse cursor changes to the appropriate
trimming cursor as explained below in the section titled
In Point, Out
Point or Slide Point Trim and Slip Trim or Rolling Trim .
5. Trim the clip as desired while monitoring and verifying the trim
operations in the Preview window.
In Point, Out Point or Slide Point Trim
Figure 469 shows the frames and trimming areas around an edit point
between two clips.
Figure 469. Edit Point Trimming Areas