Yaskawa GPD503 Drive - Manual (Page 105)

OPERATING OPERATION AT
PROCEDURE DIGITAL OPERATOR DIGITAL DISPLAY DESCRIPTION
Frequency EXAMPLE: Set frequency
Setting command to 15 Hz:
(Continued)
Move to the setting digit by
using > and make the
setting with ^ and v .
Store the frequency command Initial setting becomes frequency
value with DATA/ENTR key. command.
(This data is stored even when
the power is off).
Press DSPL key once to
change display to monitor
output frequency.
Select Select the rotation of motor GPD 503 is set for forward motor
Forward with FWD/REV key. operation, but is still in "stopped"
Operation (Red FWD lamp lights). condition.
Run Press RUN key. GPD 503 output and motor speed
(Red lamp lights. Red lamp increase smoothly at preset
at STOP key goes off). acceleration rate, then hold
steady at 15 Hz.
Select Press FWD/REV key. GPD 503 output (and motor speed)
Reverse (Red FWD lamp goes off, decreases smoothly, at preset
Operation and red REV lamp lights). deceleration rate, to zero.
Then motor begins rotation in
reverse direction, accelerating
smoothly, then holds steady
at 15 Hz.
Change Press DSPL key repeatedly Motor continues running at 15 Hz.
Frequency until frequency command
Setpoint is again displayed.
EXAMPLE: Set 50 Hz as new
value of frequency command.
Change the frequency set Motor continues running at 15 Hz.
point by using > , ^ and v .
(Procedure continued on next page)
Table 4-1. Test Run With Digital Operator - Continued
OPERATING OPERATION AT
PROCEDURE DIGITAL OPERATOR DIGITAL DISPLAY DESCRIPTION
1 5. 0
0. 0
– 1 5. 0
Value
decreasing
Value
increasing
F 0 1 5. 0
F 0 5 5. 0
F 0 5 0. 0
(–) is shown during
reverse operation
4-3
Value
increasing
(Display of current value
of output frequency)
F 0 1 0. 0
F 0 1 5. 0
F 0 1 5. 0
0. 0
0. 0
0. 0
1 5. 0