Yaskawa GPD503 Drive - Manual (Page 129)

CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
Sn-08 (Continued) XXXX Condition when Communication
Interface Card communication
error occurs:
00 = Ramp to stop (decel
time = bn-02 setting)
01 = Coast to stop
10 = Ramp to stop (decel
time = bn-04 setting)
11 = Operation continues
Sn-09 Analog Monitor XXXX 0 Analog output (terminals 0000 – –
Selection 21-22) is set by Sn-05
Method XXXX and Sn-09 XXXX
1 Analog output (terminals
21-22) is set by communi-
cation interface card (SI-B)
Analog Monitor XXXX 0 Multi-function analog 2.20
Selection output (term. 21-22)
[ also depends on Sn-05
XXXX setting ]
1 Multi-function analog
output (term. 21-22)
[ also depends on Sn-05
XXXX setting ]
XXXX – Not Used
Sn-10 Protective- XXXX 0 Stall prevention during 0000 2.29
Character- accel enabled
istics
1 Stall prevention during
Select 1
accel disabled
(Stall Prevention)
XXXX 0 Stall prevention during
decel enabled
1 Stall prevention during
decel disabled
XXXX 0 Stall prevention during
operation enabled
1 Stall prevention during
operation disabled
XXXX 0 Decel time during stall pre-
vention is "DECEL TIME 1"
(bn-02 set value)
1 Decel time during stall pre-
vention is "DECEL TIME 2"
(bn-04 set value)
Table A1-3. System Constants (Sn-XX) - Continued
CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
A1-5