Yaskawa GPD503 Drive - Manual (Page 130)

CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
Sn-11 Protective XXXX 0 Braking resistor (heat sink 0000 Separate
Character- mounted) not provided. Option
istics Overheat protection disabled. Instruction
Select 2 Sheet
(Momentary
1 Braking resistor (heat sink
Power Loss
mounted) provided. Over-
Protection)
heat protection enabled.
XXXX 0 Fault contact status during 2.5B
auto restart: remains open
1 Fault contact status during
auto restart: closes
XXXX 0 Operation stops when momen- 2.16, 2.5A
tary power loss is detected
1 Operation continues during
momentary power loss
XXXX — Not used – –
Sn-12 Protective XXXX 0 External fault signal: 0100 2.12A
Character- N.O. contact input
istics
Select 3
1 External fault signal:
(External
N.C. contact input
Fault Signal XXXX 0 External fault signal
Input at always detected
Terminal 3)
1 External fault signal only
detected during operation
XXXX Condition when external fault
signal is detected:
00 = Ramp to stop (major failure)
01 = Coast to stop (major failure)
10 = Emergency stop (major
failure)
Time to stop
determined by
bn-04 set value
11 = Continue operation
(minor failure)
Table A1-3. System Constants (Sn-XX) - Continued
CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
A1-6