Yaskawa GPD503 Drive - Manual (Page 97)

3.4 PROGRAM MODE OPERATION
A. Changing Display With DSPL Key:
ACTION DESCRIPTION DISPLAY
Apply Power DRIVE lamp is on.
— If the GPD 503 fault circuit detects
a fault, a blinking Fault code will be
displayed for 5 seconds.
— Then the Frequency Reference (An-01)
setting display appears.
Press PRGM Key
DRIVE lamp turns off. Display
DRIVE changes to first Frequency Reference
to Select Program Memory Settings constant number.
Mode (See next page for changing settings.)
Press DSPL Key Display changes to first Run Oper-
ative Settings constant number.
(See next page for changing settings.)
Press DSPL Key Display changes to first System Con-
stants number.
(See next page for changing settings.)
Press DSPL Key Display changes to first Control Con-
stants number.
(See next page for changing settings.)
Press DSPL Key Cycle begins again with first Frequency
Reference Memory Settings constant
number.
After All Pro- DRIVE lamp lights. Display shows the
gramming is Frequency Reference (An-01) setting.
Completed,
Press PRGM Key
DRIVE
to Return to
Drive Mode
F 0 0.0 0
A n - 0 1
b n - 0 1
S n - 0 1
C n - 0 1
F 0 0.0 0
3-5