Yaskawa GPD503 Drive User Manual
Page 152
Advertising
Braking Resistor (Heat Sink Mount) Installation
1.
Remove the drive from its mounting for access to the rear of the heat sink.
2.
Mount the Braking Resistor on the back of the drive’s heat sink (see Figure A7-1).
3.
Reinstall the drive in its mounting position.
4.
Connect the Braking Resistor’s leads to drive terminals according to Figure A7-2.
5.
Proceed to step 9 on page A7-8.
A7-3
Figure A7-1. Mounting Braking Resistor
on Heat SInk
BRAKING
RESISTOR
Figure A7-2. Lead Connections For Braking
Resistor (Heat Sink Mounted)
B1/+
B2
BRAKING
RESISTOR
P
B
GPD 503
Advertising