Yaskawa GPD503 Drive - Manual (Page 128)

CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
Sn-06 Operation Mode XXXX 00 = S-curve at Accel/Decel, 0000 2.27
Select 3 with 0.2 second delay
01 = S-curve at Accel/Decel
disabled
10 = S-curve at Accel/Decel,
with 0.5 second delay
11 = S-curve at Accel/Decel,
with 1.0 second delay
XXXX 0 Output frequency propor- 2.3
tional to Auto reference
1 Output frequency inversely
proportional to Auto ref.
XXXX 0 Auto Reference - Loss 2.4
Detection disabled
1 Auto Reference - Loss
Detection enabled
Sn-07 Overtorque XXXX 0 Overtorque detection is 0000 2.22
Detection disabled
1 Overtorque detection is
enabled
XXXX 0 Detects only during set
frequency
1 Detects during all
frequency conditions
XXXX 0 Operation continues after
overtorque detection
1 Coasts to stop when over-
torque is detected
XXXX – Not Used
Sn-08 Option Ref- XXXX 0 Operated from installed 0100 See
erence Select option Option
1 Operated from Digital
Instructions
Operator and/or
external terminals
XXXX 0 Run/Stop from installed
option card
1 Run/Stop from Digital
Operator and/or
external terminals
Table A1-3. System Constants (Sn-XX) - Continued
CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
A1-4