PLANET WGSD-1022 - Manual (Page 168)

5.7 Ethernet Configuration Commands
5.7.1 interface ethernet
The interface ethernet global configuration command enters the interface configuration mode to
configure an Ethernet type interface.
Syntax
interface ethernet interface
ƒ interface — Valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables ports g1 for configuration.
Console(config)# interface ethernet g1
Console(config-if)#
5.7.2 interface range ethernet
The interface range ethernet global configuration command enters the interface configuration mode to
configure multiple Ethernet type interfaces.
Syntax
interface range ethernet {port-range | all}
ƒ port-range—List of valid ports to add. Separate non consecutive ports with a comma and no
spaces; a hyphen is used to designate a range of ports.
ƒ all—All Ethernet ports.
Default Configuration
This command has no default configuration.