9 show ip igmp snooping groups, Command mode, User guidelines – PLANET WGSD-1022 User Manual
Page 198: Example, Syntax, Default configuration
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The example displays IGMP snooping information.
Console # show ip igmp snooping interface 1
IGMP Snooping is globaly disabled
IGMP Snooping is disabled on VLAN 1
IGMP host timeout is 260 sec
IGMP Immediate leave is disabled. IGMP leave timeout is 60 sec
IGMP mrouter timeout is 300 sec
Automatic learning of multicast router ports is enabled
5.9.9 show ip igmp snooping groups
The show ip igmp snooping groups user EXEC command displays the multicast groups learned by
IGMP snooping.
Syntax
show ip igmp snooping groups [vlan vlan-id] [address ip-multicast-address]
vlan_id — VLAN ID value.
ip-multicast-address — IP multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
To see the full multicast address table (including static addresses) use the show bridge address-table
command.
Example
The example shows IGMP snooping information.
Console # show ip igmp snooping groups