PLANET WGSD-1022 - Manual (Page 225)

Ports cannot be configured as a group using the interface range ethernet command.
Note:
The Port Mirroring target must be a member of the Ingress VLAN of all Mirroring source ports. Therefore,
multicast and broadcast frames in these VLANs are seen more than once. (Actually N, where N is the
number of mirroring source ports).
When both transmit (Tx) and receive (Rx) directions of more than one port are monitored, the capacity
may exceed the bandwidth of the target port. In this case, the division of the monitored packets may not
be equal. The user is advised to use caution in assigning port monitoring.
Example
The following example shows how traffic on port e8 (source port) is copied to port g1 (destination port).
Console(config)# interface ethernet g1
Console(config-if)# port monitor e8
5.16.2 show ports monitor
The show ports monitor user EXEC command displays the port monitoring status.
Syntax
show ports monitor
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how the port copy status is displayed.
Console#show ports monitor
Source Port Destination Port Type Status VLAN Tagging
---------------- ----------------------- ------------ ----------- -------------------
1/1 1/8 RX, TX Active No
1/2 1/8 RX, TX Active No
1/18 1/8 Rx Active No