PLANET WGSD-1022 - Manual (Page 321)

5.27.8 switchport access vlan
The switchport access vlan interface configuration command configures the VLAN ID when the
interface is in access mode. To reconfigure the default, use the no form of this command.
Syntax
switchport access vlan vlan-id
no switchport access vlan
ƒ vlan-id — VLAN ID of the VLAN to which the port is configured.
Default Configuration
VLAN ID=1
Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
The command automatically removes the port from the previous VLAN, and adds it to the new VLAN.
Example
The following example configures a VLAN ID of 23 to the untagged layer 2 VLAN interface number e8.
Console (config)# interface ethernet e8
Console (config-if)# switchport access vlan 23
5.27.9 switchport trunk allowed vlan
The switchport trunk allowed vlan interface configuration command adds or removes VLANs from a
trunk port.
Syntax
switchport trunk allowed vlan {add vlan-list | remove vlan-list}
ƒ add vlan-list — List of VLAN IDs to add. Separate non consecutive VLAN IDs with a comma and
no spaces. A hyphen designates a range of IDs.
ƒ remove vlan-list — List of VLAN IDs to remove. Separate non consecutive VLAN IDs with a
comma and no spaces. A hyphen designate a range of IDs.
Default Configuration
This command has no default configuration.